Citrus-based solvents cut through drivetrain grime without the harsh chemical smell that makes garage work unpleasant. Pedro's Oranj Peelz pairs citrus solvent with surfactants in a formula that's been tackling caked-on chain grease for over 20 years, and the combination handles everything from routine cleaning to stripping factory lubricant off a fresh chain before switching to wax. The low surface tension lets the degreaser creep into the tight spaces between chain plates and rollers where contamination hides, pulling oil and grit out of areas that brushing alone struggles to reach.

The formula is biodegradable and water-soluble, which simplifies the rinse process considerably. Apply Oranj Peelz to a brush or rag, scrub onto the drivetrain components, and let it sit for 3-5 minutes to break down accumulated grease. Continue scrubbing while wetting the brush with water until the dirt and oil visibly combine with the degreaser, then rinse with water from a spray bottle or low-pressure hose. The degreaser emulsifies with the water and washes away clean, leaving no residue behind that would interfere with fresh lubricant application. Let everything dry completely before applying new lube.

For chain cleaning tools like the Pedro's Chain Pig, Oranj Peelz can be diluted with two parts water for routine cleaning, saving product while still delivering enough cutting power for typical road and trail grime. For heavily contaminated chains, use it at full strength and plan on extra rinse cycles. The degreaser also works well for small parts cleaning: drop bearings, hardware, or a pulled chain into a sealed container with enough Oranj Peelz to coat the surfaces, shake vigorously for a couple minutes, add water to submerge the parts, and repeat the shake-and-rinse cycle until the water runs clear.... Read More