Lock-on grips solve a problem that plagues friction-fit designs: rotation under load. When you're pulling hard on the bars through technical terrain or hauling on the brakes during a steep descent, the last thing you need is your grip interface shifting position. The Ritchey WCS Locking TrueGrips use aluminum collars at both ends that cinch down with 3mm hex bolts, mechanically securing the grip to your handlebar rather than relying on friction alone. Once tightened, these grips stay exactly where you position them regardless of conditions or riding intensity.

The grip compound itself uses a dual-density construction that places softer material where your hands make primary contact while maintaining firmer rubber at the collar interfaces for secure clamping. This approach provides vibration damping without the vague, spongy feel that comes from uniformly soft grips. The ergonomic shape includes a subtle taper from the inner to outer diameter, following the natural geometry of a closed fist and reducing the grip force needed to maintain control.

Installation takes about two minutes per side with no grip glue, hairspray, or waiting for adhesive to cure. Loosen the collar bolts, slide the grip into position, and tighten to spec. This same simplicity applies to removal—if you need to swap grips between bikes or replace worn units, the collars release cleanly without the wrestling match that friction-fit grips demand. The WCS designation indicates these sit in Ritchey's performance tier, using the same construction standards applied across their competition component line.... Read More