Free Shipping on Orders Over $99

Free Shipping Policy

Free Shipping applies to all orders placed for $99 and above
(pre-tax value). Some restrictions apply:

  • Offer valid in the Lower 48 States only
  • Excludes Travel Cases and some other oversize items (prices can be calculated in the cart before checkout)
Take 10% off first full priced item with: TAKE10
X

CODE: TAKE10

Offer valid for 10% off qualifying items.

Some exclusions apply.

For questions, contact us by calling 1.800.627.6664 or Chat Now

Park Tool RT-2 Head Cup Remover- Oversized

There are plenty of oversized head tubes that still use a press-in headset cup, especially at the 1.5" lower end. Oddly enough, riders who have such frames report less creaking than many riders with simple drop-in style units; hmm. Park has always made the right tool for the job, so stop bending your RT-1 to get cups out of oversized headtubes. The RT-2 Oversized Head Cup Remover was designed for 1 1/4 and up head tubes and when properly used, and when it is used properly, you can protect and preserve your frame and head cups with the flared of this simple, but crucial, steel tool.

Simply slide the RT-2 into the headtube from the end you want to remove a cup from. Once the flared ends slide up into the cup and you hear a click, you should be good to go to drive it out. However, we recommend you inspect carefully, using a flashlight if necessary, to ensure the tool ends are sitting on the cup and not some random protrusion or lip inside the headtube. Satisfied? Now you can strike the impact head of the tube with a hammer to drive the cup out straight. Often this takes one sharp blow, but if it takes more than one, make sure, again, that the tool is seated on the cup before re-striking.

As a bonus, the RT-2 can also be used to drive out cups on one-piece cranksets. We have even seen it used as an impromptu flower delivery carrier. Ah, bike people. It is not everyday you get flowers in a heat-treated alloy steel tool with a fine nickel finish. Every shop and race mechanic should have an RT-2, and if you are a home mechanic with an oversized head tube and pressed-in headset cups, put down the long screwdriver or hex wrench, and pick the Park RT-2 Head Cup Remover- Oversized, and get the job done properly, without risking the integrity of your frame or headset cups.

Details

  • Flared-end tool used to drive out pressed in headset cups in oversized headtubes
  • Designed for the 1-1/4" and 1-1/2" headset standards
  • Also easily removes cups on one-piece cranks
  • Strong, heat treated alloy steel with a nickel finish
  • SHIS Terminology: remove cups of ZS44, ZS49, ZS55, ZS56, EC49, EC56 headsets
  • Before every strike of the tool head, ensure the flared ends are seated properly on cup
$34.95
Item is in stock

Reviews

No reviews. Be the first. Write Review